This May help you see about what it takes to make A rearend & alxes. This is just for SHOW. I have never made this setup. With out parts in hand, Its not ture, But can get you close to the parts needed. Again Just for show!!!!!!!!!!!!!!!!! Using KEY WAYS, Should Be welded.
As it WILL NOT HOLD, HIGHER CC ENGINES!!!!!!!!
60 tooth sprocket # 50 - 5/8"pitch. McMaster Carr
Prices are 40.36 +s/h
Call Them @ 630 833 0300
part # 2299 K59
Its A Blank Sprocket!!!!!!
Again Just for show!!!!
A #50 sprocket from parts store
will work on a #530 Chain!!!
This Can Also Be Used For A 4 U-Joint Setup,( 5 LINK OR Trailing Arms)
By Just Changing The Axles Some & Outer Carrier! LIKE 3 Centers!
A Arms, I get asked about a arms all the time. They can be built many ways. Below are some I have made just to show. I Made these in my off time. Thanks
J Arms, used scrap steel. A arms with drop shock loop. New style A arms for our frame
I used 4 wheeler a arms,
For this setup. Welded
ends in. Made them 27" Other style for our frames
This is just to help you see what can be done with just alittle work. Most made from scrap tubing I had setting around. 4 wheeler a- arms(left, bottom) are easy. & will work for mini's. Not the best looking, but are cheap to make. Thanks Alan
